Folks,
cc: Micheal Robinton

I just installed the package on two desktop systems, each with a
different Belkin UPS and after reading the README files and examining
both the /etc/default/upsd and the /etc/upsd.conf files. I have the
following questions:

1. How do you indicate the correct USB Device name in /etc/default/upsd
( the one for the serial connection is correct)?

2. How do you determine the pin-outs for the supplied cables? I will try
asking Belkin tech support, in the morning, but I do not know how much
info I will get from them. If anyone knows please let me know...

The information I have about the units and the current settings in the
files are:

Unit 1 (Belkin F6H375-USB)
/etc/default/upsd contains: /dev/ttyS0 <-- I doubt that this is right...

Unit 2 (Belkin F6C800-SER)
/etc/default/upsd contains: /dev/ttyS0 <-- This is correct

/etc/upsd.conf shows two entries; neither is for my unit types... are
ALL Belkin upsd cables the same?

When I start the Daemon using: sudo /etc/init.d/upsd start
Both start up however Unit 1 (USB) has an entry in syslog showing
UPS-ERROR (Which in light of the wrong entry in the /etc/default/upsd
file is not surprising). Unit 2 (SER) on the other hand reports
LOW-BATTERY regardless of which one of the two options contained in
/etc/upsd.conf I use. One is for an APC or compatible UPS in 'dumb' mode
and the other is for a Belkin resource F5C520c. Both Daemons continue to
run...

NOTE: I have a version of the Belkin Bulldog software available to me
but I would rather use the supplied (multiverse) package. The Belkin S/W
shows the status information for Unit 2 correctly, however it is a
resource hog!

--


Jay Ridgley
jridgley2@(protected)
Registered Linux User ID - 9115


--
ubuntu-users mailing list
ubuntu-users@(protected)
Modify settings or unsubscribe at: https://lists.ubuntu.com/mailman/listinfo/ubuntu-users