Hi,

On a HP Proliant dl-140-g3 with Adaptec SATA controller I'm trying to
install RHELS5.1 . Both SATA disks are configured in a RAID 1 set (via
the SATA controller internal setup utility), properly recognized as 1
device during RH installation and mapped in /dev/mapper . Creating a
/boot partition and a LVM2 VG group on the dev-mapper device. All going
well, but when rebooting the system after installation, it does not
setup de dev-mapper device. RH sees both disks as separate disks
(/dev/sda and /dev/sdb), not as during installation as a device-mapper
device. Any ideas how to correct this?

Tia,
Andre

---
Wageningen University
The Netherlands



_______________________________________________
rhelv5-list mailing list
rhelv5-list@(protected)
https://www.redhat.com/mailman/listinfo/rhelv5-list