On Jan 30, 2008 6:47 AM, Jos Vos <jos@(protected):

> In the meantime I found out that probably the on-board Realtek
> won't work without an additional driver. This CentOS page tells
> more:
>
>  http://wiki.centos.org/HardwareList/RealTekRTL8111b
>
> Strangely enough, this also mentions that F8 won't work...
> What does "lspci -v" say on your board?

Works fine. Here is lspci:

03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI E
xpress Gigabit Ethernet controller (rev 01)
    Subsystem: Intel Corporation Unknown device d608
    Flags: bus master, fast devsel, latency 0, IRQ 17
    I/O ports at c000 [size=256]
    Memory at d0020000 (64-bit, non-prefetchable) [size=4K]
    Expansion ROM at d0000000 [disabled] [size=128K]
    Capabilities: [40] Power Management version 2
    Capabilities: [48] Vital Product Data <?>
    Capabilities: [50] Message Signalled Interrupts: Mask- 64bit+ Queue=0/1
Enable-
    Capabilities: [60] Express Endpoint, MSI 00
    Capabilities: [84] Vendor Specific Information <?>
    Kernel driver in use: r8169
    Kernel modules: r8169

And here is ethtool:

Settings for eth0:
    Supported ports: [ TP ]
    Supported link modes:  10baseT/Half 10baseT/Full
                    100baseT/Half 100baseT/Full
                    1000baseT/Full
    Supports auto-negotiation: Yes
    Advertised link modes: 10baseT/Half 10baseT/Full
                    100baseT/Half 100baseT/Full
                    1000baseT/Full
    Advertised auto-negotiation: Yes
    Speed: 1000Mb/s
    Duplex: Full
    Port: Twisted Pair
    PHYAD: 0
    Transceiver: internal
    Auto-negotiation: on
    Supports Wake-on: pumbg
    Wake-on: g
    Current message level: 0x00000033 (51)
    Link detected: yes

--
C Lance Moxley
http://moxley.us/

_______________________________________________
rhelv5-list mailing list
rhelv5-list@(protected)
https://www.redhat.com/mailman/listinfo/rhelv5-list