Hi
It has been asked and answered in detail quite recently.

Have a look through the archives for March and April searching for
bonding.

https://www.redhat.com/archives/redhat-list/

Regards

> -----Original Message-----
> From: redhat-list-bounces@(protected)-
> bounces@(protected)
> Sent: 14 April 2008 09:13
> To: General Red Hat Linux discussion list
> Subject: Redhat Linux network teaming/bonding
>
> Hi,
>
> How do we configure network bonding (if possible, using one
> single IP addr) on RHEL & Redhat 7?
>
> The following Sun website give me exactly what I needed
> for Solaris 10 (but I'm new to Linux) :
> http://docs.sun.com/app/docs/doc/816-4554/gafxi?a=view
>
> If possible, avoid IPMP protocol configuration.
>
> Active-active or active-passive network links setup are both
> welcome. Priority is to provide redundancy but traffic load-
> sharing will be good to have too
>
> This has probably been answered in the past but pardon me
> as I'm new. Appreciate if someone can also tell me how to
> search past postings/archive.
>
> Kindly highlight any special handling on the Cisco 6513
> switch end if you know (ie both network ports must be
> within the same chassis?)
>
>
> Thanks
> U
> --
> redhat-list mailing list
> unsubscribe mailto:redhat-list-request@(protected)
> https://www.redhat.com/mailman/listinfo/redhat-list

--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@(protected)
https://www.redhat.com/mailman/listinfo/redhat-list