 | | | ifconfig only show interface loopback | ifconfig only show interface loopback 2007-02-08 - By Stanley, Jon
Back
What kind of card is it? It does not matter if the cable is plugged in
during installation - it will configure the interface for DHCP by
default if the card is supported. My guess is that you have unsupported
hardware, and either it will not work (there is no Linux driver for it),
or you will have to load a third-party driver for the card.
The output of lspci would be helpful.
> -- --Original Message-- --
> From: taroon-list-bounces@(protected)
> [mailto:taroon-list-bounces@(protected)] On Behalf Of Leuy Eeelyu
> Sent: Thursday, February 08, 2007 2:22 PM
> To: taroon-list
> Subject: ifconfig only show interface loopback
>
> Hi.. I just installed my RHEL ver 3. As I did not plug the
> cable to my ethernet port during the
> installation. I found ifconfig only show interface lo
> (loopback). May I know how to enable eth0,
> I had plug in cable to Eth0 and restart but it still doesn't come up
>
> I went to /etc/sysconfig/network-scripts/ folder I only found
> ifcfg-lo and I don't see ifcfg-eth0,
> I tried to copy ifcfg-lo to ifcfg-eth0 and edit but I found
> that I don't know eth0's MAC addresss
>
> I also went to Gnome GUI-->Network--> add Ethernet connection
> but I failed to activate it , it
> prompt me driver not correct, I tried to select the driver
> from the list but no luck all not
> correct
>
> Any help ?
>
>
>
> __ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____
> __ ____ ____ ____ ____
> Want to start your own business?
> Learn how on Yahoo! Small Business.
> http://smallbusiness.yahoo.com/r-index
>
> --
> Taroon-list mailing list
> Taroon-list@(protected)
> https://www.redhat.com/mailman/listinfo/taroon-list
>
--
Taroon-list mailing list
Taroon-list@(protected)
https://www.redhat.com/mailman/listinfo/taroon-list
|
|
|