use eth1 instead? 2007-10-29 - By chuck lawrence
Back
hi,
I have a RHES 3 system with 3 NICs. I'm using one that is 10/100, but I
want to switch to one of the others, which are 10/100/1000.
I've edited /etc/sysconfig/network-scripts/ifcfg-eth1 and eth2, using
the values from eth0.
is there anything else to do, other than switch the cable? eth1 and eth2
weren't configured at boot time. will running ifconfig manually
suffice, or do I have to reboot?
adv(thanks)ance
-chuck
__ ____ ____ ____ ____ ____ ____ ____ ____ ____
Redhat-install-list mailing list
Redhat-install-list@(protected)
https://www.redhat.com/mailman/listinfo/redhat-install-list
To Unsubscribe Go To ABOVE URL or send a message to:
redhat-install-list-request@(protected)
Subject: unsubscribe
|
|
