 | | | Module loading on Boot | Module loading on Boot 2003-12-16 - By Neil Marjoram
Back
I 've just installed an Adaptec 2400A into my RH9 system.
I booted up kudzu detected and installed the 2400 card and I ran
modprobe dpt_i2o and all is well. Created filesystem, mounted etc.
I checked the /etc/modules.conf file for the required entry - all is OK,
and rebooted.
Now it 's not there. There are no errors at boot up, and when I log in
and execute modprobe all is well again.
What can I do to get the module to load at boot time ? I thought all you
needed was the correct entry in /etc/modules.conf.
Thanks,
Neil.
--
Neil Marjoram
Systems Manager
UCL Adastral Park Campus
Ross Building
Martlesham Heath
Ipswich
Suffolk
IP5 3RE
|
|
|