 | | | CD-RW problems | CD-RW problems 2003-05-03 - By Mike Chambers
Back
I had problems with my cd-rw last night, with it always seeming to be
busy, as in the light blinking, and couldn 't open it or anything. I
rebooted a few times, it was very slow to boot up, either in linux or
into XP.
This is what I see from my logs this morning..
May 2 23:39:50 bart kernel: hdd: drive not ready for command
May 2 23:39:50 bart kernel: hdd: ATAPI reset complete
May 2 23:39:50 bart kernel: hdd: status error: status=0x7f { DriveReady
DeviceFault SeekComplete DataRequest CorrectedError Index Error }
May 2 23:39:50 bart kernel: hdd: status error:
error=0x7fIllegalLengthIndication EndOfMedia Aborted Command
MediaChangeRequested LastFailedSense 0x07
And these errors as well..
May 2 23:31:25 bart kernel: hdd: irq timeout: status=0x80 { Busy }
May 2 23:31:25 bart kernel: hdd: status timeout: status=0x80 { Busy }
May 2 23:31:25 bart kernel: hdd: drive not ready for command
May 2 23:31:25 bart kernel: hdd: ATAPI reset complete
May 2 23:31:30 bart kernel: scsi : aborting command due to timeout :
pid 65, scsi0, channel 0, id 0, lun 0 Prevent/Allow Medium Removal 00 00
00 01 00
May 2 23:31:30 bart kernel: SCSI host 0 abort (pid 65) timed out -
resetting
May 2 23:31:30 bart kernel: SCSI bus is being reset for host 0 channel
0.
Is this a hardware problem or something else, like kernel or something?
If kernel or program, should I bugzilla and what component?
--
Mike Chambers
Madisonville, KY
"Hand over the code, and no one gets hurt! "
|
|
|