startx and Blank screen 2003-01-17 - By Ian Firla
Back
Perhaps you can post the relevant output from /var/log/messages
Ian
-- ---- ----
Dr Ian Firla
Robert Graves Trust | "A partial count of the software available
St John's College, Oxford | in just one noncommerical Linux system
OX1 3JP - +44-(0)7855-310565 | would have cost about $1.9 billion to develop
http://www.robertgraves.org | ... the way Microsoft does it" Bruce Perens
On Fri, 17 Jan 2003, Shriram NK wrote:
> Hello,
> I do not know if this is the proper forum, if not my apologies and a pointer
to FAQ/user group to solve my problem will be greatly appreciated.
>
> The problem:
> I have a HP Pavillion N3390 Laptop
> Monitor adapter - Silicon Lynx 3DM
> Monitor - Unknown (14 " laptop display panel)
> RH 7.1 being run
> The OS has been installed and set to run in text mode.
> After running 'Xconfigurator' and setting up Vertical frequencies, Display
type, etc ; the configurator makes a 'test display' of KDE desktop properly.
Subsequently when 'startx' is given the X session starts up, but within 5
seconds while its still initializing the peripherals, the screen goes blank.
ctrl-alt-+ OR ctrl-alt-minus OR ctrl-alt-backspace do not seem to have any
effect and I have to reboot. Doesnt even go back to text mode !!!
>
> I have followed most readily accessible RH FAQs and XFree86 FAQs and tried
various things without luck.
> A solution to above will be greatly appreciated, an explanation of this
peculiar behaviour, even more so.
> regards
> sriram
>
|
|
