 | | | How to use another hard disk? | How to use another hard disk? 2004-02-05 - By jason pearl
Back
On Fri, 06 Feb 2004 08:33:36 +0800
Edward King <zhangsc@(protected) > wrote:
| > I have two hard disk.I installed Red Hat 7.2 into the first hard disk,then
|I want to visited the data of second hard disk,I know I need to use command
|like follow : > #mount /dev/sda /mnt/seconddisk
| >
| > But I don 't know the device number of second disk:
| > #mount /dev/??? /mnt/seconddisk
| >
| > How to know it? What commands to use?
| > Any idea will be appreciated!
| >
| > Edward
| >
most likely if you have sda as your first drive.... your seconddrive will be
sdb
i have 5 drives and they are hdb hde hdg hdi hdk it all depends where on the
board you are putting it on. if its a slave on the primary controller it will
be sdb or hdb secondary master will be hdc or scd0
aditional cards start with hde like mine does
hope this helps
kudzu should pop up during boot after the drive is detected so it should be
easy to setup.
-- jason pearl <jason@(protected) >
++++++++++++++++++
"Keep your friends close and your enemies closer "-Tupac
++++++++++++++++++
Kurrupted Visionz Phx, AZ registered linux user #307811
RHEL WS 3.0 Linux Machine# 193475, 227341
AMD64 Opteron 1.6 ASUS SK8N
http://counter.li.org
uptime
17:36:30 up 4:30, 1 user, load average: 0.11, 0.23, 0.61
|
|
|