 | | | Milter not being used in sendmail-8.12.8-9.90 | Milter not being used in sendmail-8.12.8-9.90 2004-02-11 - By Michael St. Laurent
Back
Cowles, Steve <mailto:steve@(protected)> wrote:
> First, I have never used clamv, but I haved used other sendmail
> milters. The key to my success with using milters was specifying the
> same socket name when I start the milter process. With that in mind...
Yeah, I started with this on the clamav lists and only started posting here
when they said "Clamav and the clamav-milter is starting and working
correctly and we can't see any reason your sendmail config would not be
working either, but... sendmail, for whatever reason, is not communicating
with the clamav-milter process."
> When you start clamv... are you specifying that it use the socket name
> specifed above?
>
> i.e. /var/run/clamav/clamav-milter.sock
>
> FWIW: With the milters I have used, the socket name is usually
> specifed with a command line argument. Something like: clamv
> --socket=/var/run/clamav/clamav-milter.sock
Yep, the socket is in place and as far as I can tell the permissions should
be OK:
[root@(protected) root]# cd /var/run
[root@(protected) run]# ls -ld clamav
drwxrwxrwx 2 clamav clamav 4096 Feb 9 09:00 clamav
[root@(protected) run]# ls -l clamav
total 4
srwxrwxrwx 1 clamav clamav 0 Feb 9 09:00 clamav-milter.sock
-rw-rw---- 1 clamav clamav 4 Feb 9 09:00 clamd.pid
srwxrwxrwx 1 clamav clamav 0 Feb 9 09:00 clamd.sock
[root@(protected) run]#
We were all quite puzzled and so I turned to the ultimate source of
technical knowledge... the Red Hat support lists! ;-D
--
Michael St. Laurent
Hartwell Corporation
--
Shrike-list mailing list
Shrike-list@(protected)
https://www.redhat.com/mailman/listinfo/shrike-list
Earn $52 per hosting referral at Lunarpages.
|
|
|