 | | | last thing question | last thing question 2004-04-21 - By GoijI P
Back
well, since security is not an issue for my small network, i use telnet (bad
as something getting used to) to connect local HostA to remote HostB. This
happens after Host A is connected to Host B via telnet and after done setenv
,,, xhost + ,,,, xterm etc.
i cd to path that an HostB executable is and try to execute it remotely from
HostA 's xterm session but i get "command not found ". From Host B consol i
run same command within same path , no problem. Tried "HostBexe " or
"./HostBexe " from HostA, no difference. Firewall on HostA is disabled.. i 'll
connect a solaris box to my network to see if that bahaves differently than
Redhat9 box. (HostA,HostB are Redhat9 boxes). any guess as what might be the
cause?.
__ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ __
Lose those love handles! MSN Fitness shows you two moves to slim your waist.
http://fitness.msn.com/articles/feeds/article.aspx?dept=exercise&article=et_pv_030104_lovehandles
__ ____ ____ ____ ____ ____ ____ ____ ____ ____
Redhat-install-list mailing list
Redhat-install-list@(protected)
https://www.redhat.com/mailman/listinfo/redhat-install-list
To Unsubscribe Go To ABOVE URL or send a message to:
redhat-install-list-request@(protected)
Subject: unsubscribe
|
|
|