 | | | Tape drive settings | Tape drive settings 2004-05-12 - By Wolfgang Gill
Back
> -- --Original Message-- --
> From: shrike-list-bounces@(protected)
> [mailto:shrike-list-bounces@(protected)] On Behalf Of Michael
> St. Laurent
> Sent: Thursday, 13 May 2004 12:04 AM
> To: 'shrike-list@(protected)'
> Subject: Tape drive settings
>
>
> Hello to the list! ;-D
>
> I've just installed an Adaptec 29160N SCSI controller card
> (it's a SCSI-160 type card) with a Quantum VS160 DLT tape
> drive. Is there anything special I need to do to ensure
> maximum throughput to the tape drive or will it all just
> autoconfigure that way?
>
> --
> Michael St. Laurent
> Hartwell Corporation
[snip]
Just make sure that it's on it's own channel. And nothing else is on that
channel with it. And your ok. If you were to put it on the same channel as
say, the HDD, then the harddrive will slow down to the tape drive transfer
speed and the backup rate will be very slow. But if it's on it's own, then
you will get maximum transfer.
Wolf
######################################################################
Attention:
This e-mail message is privileged and confidential. If you are not the
intended recipient please delete the message and notify the sender.
Any views or opinions presented are solely those of the author.
This e-mail has been scanned and cleared by MailMarshal
www.marshalsoftware.com
######################################################################
--
Shrike-list mailing list
Shrike-list@(protected)
https://www.redhat.com/mailman/listinfo/shrike-list
Earn $52 per hosting referral at Lunarpages.
|
|
|