 | | | Anyone has IBM HS20 Blades with copper pass-thru module? | Anyone has IBM HS20 Blades with copper pass-thru module? 2005-02-01 - By Christopher McCrory
Back
Hello...
On Wed, 2005-02-02 at 09:52 +1300, Bojan Zdrnja wrote:
> Hi,
>
> We have quite a bit of IBM HS20 Blades.
> BladeCentre basically has one Dlink switch, which is shared among all Blades
> in the chassis.
> This is not good for some of our server which have different requirements,
> so we had to buy a copper pass-thru module, which allows direct 1gbit
> network connection for each Blade.
>
I don't currently have a IBM HS20, but the Dell blades with pass-through
were 1000/full only (hard coded).
/sbin/ethtool -s eth0 autoneg off speed 1000 duplex full
similar on upstream switch.
no guarantees though
<snip>
--
Christopher McCrory
"The guy that keeps the servers running"
chrismcc@(protected)
http://www.pricegrabber.com
Let's face it, there's no Hollow Earth, no robots, and
no 'mute rays.' And even if there were, waxed paper is
no defense. I tried it. Only tinfoil works.
--
Taroon-list mailing list
Taroon-list@(protected)
http://www.redhat.com/mailman/listinfo/taroon-list
Earn $52 per hosting referral at Lunarpages.
|
|
|