 | | | Software RAID1 | Software RAID1 2005-04-18 - By Jussi Silvennoinen
Back
> I setup a system with software RAID 1 mirroring, however the commands
> that I used in RHEL 3 to make sure both disks are bootable do not seem
> to work in RHEL 4. I used to execute the following commands in RHEL 3:
>
> grub
> install --stage2=/boot/grub/stage2 (hd0,0)/grub/stage1 (hd0)
> (hd0,0)/grub/stage2 p /grub/grub.conf
> install --stage2=/boot/grub/stage2 (hd1,0)/grub/stage1 (hd1)
> (hd1,0)/grub/stage2 p /grub/grub.conf
> quit
>
> Now if I do this I get "Segmentation Fault" on the first "install" command.
Disable NX-protection from BIOS or boot with noexec=off.
--
Jussi
--
Taroon-list mailing list
Taroon-list@(protected)
http://www.redhat.com/mailman/listinfo/taroon-list
Earn $52 per hosting referral at Lunarpages.
|
|
|