 | | | How to compile driver for ITE 8212? | How to compile driver for ITE 8212? 2005-05-03 - By Thom DeCarlo
Back
Thanks Jussi,
You reminded me that there were a couple more steps that I forgot from the
installation guide. I've gotten the patches in place and now can see the
disk on the ITE controller.
Thanks a lot to everyone who took the time to answer my newbie questions.
I'm sure there will be more, so I hope you'll put up with me for a while
longer.
Thom
--
Thom DeCarlo
-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- --
Confidence is the feeling you get
before you fully understand the situation.
> -- --Original Message-- --
> From: Jussi Silvennoinen
> Sent: Tuesday, May 03, 2005 1:25 AM
> To: taroon-list@(protected)
> Subject: RE: How to compile driver for ITE 8212?
>
>
> Did you actually load the driver? Modinfo doesn't do that and lspci just
> prints PCI-bus information. Nothing regarding the actual driver AFAIK.
> 'modprobe iteraid' and 'dmesg' after that. 'fdisk -l' should
> show a unpartitioned drive afterwards.
>
> --
>
> Jussi
>
--
Taroon-list mailing list
Taroon-list@(protected)
http://www.redhat.com/mailman/listinfo/taroon-list
Earn $52 per hosting referral at Lunarpages.
|
|
|