 | | | Network Not Working in Linux ; Works in Windows Why ? | Network Not Working in Linux ; Works in Windows Why ? 2005-05-09 - By John Smith
Back
Hi,
I have just installed RedHat in my system (Dual OS : Windows and
Linux)
I can ping any system on the network under windows.
But, when i ping any system on the network under Linux I get,
Undestination Unreachable error.
I have Inter Pro 100 Ethernet card on my system.
The Static IP is same for Windows and Linux.
When i do ifconfig ; i am getting ip, netmask everything is ok. except
Tx Packets and Rx Packets which are 0.
I tried
cardctl ident
I got an message saying no devices in /proc/devices.
I dont know what is the problem.
I checked The driver is e100 it is loaded. but still network is not
working.
Please advice.
Would appreciate if you could tell me what (steps) i should do inorder
to correct my problem.
List Of Commands and thier results:
john.maxi...@(protected) May 6, 6:32 pm show options
Newsgroups: comp.os.linux.setup, comp.os.linux.networking
From: john.maxi...@(protected) - Find messages by this author
Date: 6 May 2005 06:02:09 -0700
Local: Fri,May 6 2005 6:32 pm
Subject: Re: Destination Unreachanble: Fedora Core 2 : Network Does not work.
Reply | Reply to Author | Forward | Print | Individual Message | Show
original | Report Abuse
Hi,
I am giving the outputs of the following command for assitance.
Name Network Card: Inter Pro 100
Nature Of Problem: Network Works while in Windows (i am able to ping to
any machine). But, in Linux it does Not Work, unable to ping to any
machine on network.
get Errror: Destination Host Unrechable.
Details Of Commands Executed:
-- ---- ---- ---- ---- ---- --?-- ---- ---- --
Command: cardctl ident
no pcmcia driver in /proc/devices
-- ---- ---- ---- ---- ---- --?-- ---- ---- -----
Command: ifconfig -a
-- ---- ---- ---- ---- ---- --?-- ---- ---- ----
eth0 Link encap:Ethernet HWaddr 00:00:E2:49:1A:A9
inet addr:XX.YY.13.88 Bcast:192.168.13.255
Mask:255.255.255.0
inet6 addr: fe80::200:e2ff:fe49:1aa9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:2389 errors:0 dropped:0 overruns:0 frame:0
TX packets:2389 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2724120 (2.5 Mb) TX bytes:2724120 (2.5 Mb)
sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
-- ---- ---- ---- ---- ---- --?-- ---- ---- ---- --
Command: /sbin/iptables -L
Chain INPUT (policy ACCEPT)
target prot opt source destination
Chain FORWARD (policy ACCEPT)
target prot opt source destination
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
-- ---- ---- ---- ---- ---- --?-- ---- ---- ---- ---- ---
Command: /sbin/route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
XX.YY.13.0 0.0.0.0 255.255.255.0 U 0 0 0
eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0
eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0
lo
0.0.0.0 XX.YY.13.1 0.0.0.0 UG 0 0 0
eth0
-- ---- ---- ---- ---- ---- --?-- ---- ---- ---- ---- ---
Command: cat /etc/sysconfig/network
NETWORKING=yes
HOSTNAME=ShriRama
-- ---- ---- ---- ---- ---- --?-- ---- ---- ---- ---- ---
Command: cat /etc/sysconfig/network
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=XX.YY.13.88
NETMASK=255.255.255.0
GATEWAY=XX.YY.13.1
-- ---- ---- ---- ---- ---- --?-- ---- ---- ---- ---- ----
Command: cat /etc/resolv.conf
nameserver XX.YY.10.1
-- ---- ---- ---- ---- ---- --?-- ---- ---- ---- ---- ---- --
Command : /sbin/lsmod
Module Size Used by
iptable_filter 2048 0
ip_tables 13440 1 iptable_filter
parport_pc 19392 1
lp 8236 0
parport 29640 2 parport_pc,lp
autofs4 10624 0
sunrpc 101064 1
e100 25348 0
mii 3584 1 e100
floppy 47440 0
sg 27552 0
scsi_mod 91344 1 sg
microcode 4768 0
dm_mod 33184 0
joydev 6976 0
uhci_hcd 23708 0
button 4504 0
battery 6924 0
asus_acpi 8472 0
ac 3340 0
ipv6 184288 8
ext3 102376 3
jbd 40216 1 ext3
The Output of lspci corresponding to my adapter is
01:08:0 Ethernet Controller: Intel Corp
82801 BA/BAM/CA/CAM Ethernet Controller (rev 01)
Hope this helps to identify my problem.
Regards,
John
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@(protected)?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
Earn $52 per hosting referral at Lunarpages.
|
|
|