 | | | system down - can 't find luns (more info) | system down - can 't find luns (more info) 2005-05-23 - By Dana Holland
Back
When I do modprobe -r qla2300 and then modpdrobe -v qla2300, I see this
in the /var/log/messages file - this means that the box sees the LUNs,
right?
May 23 09:48:53 apollo16 kernel: scsi : 1 host left.
May 23 09:48:58 apollo16 kernel: qla2x00_set_info starts at address =
f8832060
May 23 09:48:58 apollo16 kernel: qla2x00: Found VID=1077 DID=2312
SSVID=1077 SSDID=100
May 23 09:48:58 apollo16 kernel: scsi(1): Found a QLA2312 @ bus 9,
device 0x4, irq 82, iobase 0xcc00
May 23 09:48:58 apollo16 kernel: scsi(1): Allocated 4096 SRB(s).
May 23 09:48:58 apollo16 kernel: scsi(1): Configure NVRAM parameters...
May 23 09:48:58 apollo16 kernel: scsi(1): 64 Bit PCI Addressing Enabled.
May 23 09:48:58 apollo16 kernel: scsi(1): Verifying loaded RISC code...
May 23 09:48:58 apollo16 kernel: scsi(1): Verifying chip...
May 23 09:48:58 apollo16 kernel: scsi(1): Waiting for LIP to complete...
May 23 09:48:58 apollo16 kernel: scsi(1): LIP reset occurred.
May 23 09:48:58 apollo16 kernel: scsi(1): LIP occurred.
May 23 09:48:58 apollo16 kernel: scsi(1): LOOP UP detected.
May 23 09:48:58 apollo16 kernel: scsi(1): Topology - (F_Port), Host Loop
address 0xffff
May 23 09:48:59 apollo16 kernel: qla2x00: Found VID=1077 DID=2312
SSVID=1077 SSDID=100
May 23 09:48:59 apollo16 kernel: scsi(2): Found a QLA2312 @ bus 10,
device 0x3, irq 77, iobase 0xbc00
May 23 09:48:59 apollo16 kernel: scsi(2): Allocated 4096 SRB(s).
May 23 09:48:59 apollo16 kernel: scsi(2): Configure NVRAM parameters...
May 23 09:48:59 apollo16 kernel: scsi(2): 64 Bit PCI Addressing Enabled.
May 23 09:48:59 apollo16 kernel: scsi(2): Verifying loaded RISC code...
May 23 09:48:59 apollo16 kernel: scsi(2): Verifying chip...
May 23 09:48:59 apollo16 kernel: scsi(2): Waiting for LIP to complete...
May 23 09:48:59 apollo16 kernel: scsi(2): LIP reset occurred.
May 23 09:49:00 apollo16 kernel: scsi(2): LIP occurred.
May 23 09:49:00 apollo16 kernel: scsi(2): LOOP UP detected.
May 23 09:49:00 apollo16 kernel: scsi(2): Topology - (F_Port), Host Loop
address 0xffff
May 23 09:49:01 apollo16 kernel: scsi1 : QLogic QLA2312 PCI to Fibre
Channel Host Adapter: bus 9 device 4 irq 82
May 23 09:49:01 apollo16 kernel: Firmware version: 3.01.18,
Driver version 6.04.01-fo
May 23 09:49:01 apollo16 kernel: scsi2 : QLogic QLA2312 PCI to Fibre
Channel Host Adapter: bus 10 device 3 irq 77
May 23 09:49:01 apollo16 kernel: Firmware version: 3.01.18,
Driver version 6.04.01-fo
May 23 09:49:01 apollo16 kernel: blk: queue f5e55a18, I/O limit 4095Mb
(mask 0xffffffff)
May 23 09:49:01 apollo16 kernel: Vendor: IBM Model: 3542
Rev: 0520
May 23 09:49:01 apollo16 kernel: Type: Direct-Access
ANSI SCSI revision: 03
May 23 09:49:01 apollo16 kernel: blk: queue f5e55818, I/O limit 4095Mb
(mask 0xffffffff)
May 23 09:49:01 apollo16 kernel: Vendor: IBM Model: 3542
Rev: 0520
May 23 09:49:01 apollo16 kernel: Type: Direct-Access
ANSI SCSI revision: 03
May 23 09:49:01 apollo16 kernel: blk: queue f5e55618, I/O limit 4095Mb
(mask 0xffffffff)
May 23 09:49:01 apollo16 kernel: scsi(1:0:0:0): Enabled tagged queuing,
queue depth 16.
May 23 09:49:01 apollo16 kernel: scsi(1:0:0:1): Enabled tagged queuing,
queue depth 16.
May 23 09:49:01 apollo16 kernel: blk: queue f5e55618, I/O limit 4095Mb
(mask 0xffffffff)
May 23 09:49:01 apollo16 kernel: Attached scsi disk sdb at scsi1,
channel 0, id 0, lun 0
May 23 09:49:01 apollo16 kernel: Attached scsi disk sdc at scsi1,
channel 0, id 0, lun 1
May 23 09:49:01 apollo16 kernel: SCSI device sdb: 285212672 512-byte
hdwr sectors (146029 MB)
May 23 09:49:01 apollo16 kernel: sdb: sdb1
May 23 09:49:01 apollo16 kernel: SCSI device sdc: 288118784 512-byte
hdwr sectors (147517 MB)
May 23 09:49:01 apollo16 kernel: sdc: sdc1
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@(protected)?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
Earn $52 per hosting referral at Lunarpages.
|
|
|