ext3 extension on Storagetek 210 disk array 2005-10-07 - By Bob Flynn
Back
Hi,
I have a question about extending ext3 partitions on a fibre attached
Storagetek 210 disk array.
Is the necessary to create the ext3 partition upon the partition
presented by the storagetek device after configuration via SANtricity,
or should you
use LVM to create a further logical layer between the filesystem and the
disks.
Will LVM add anything, or can I simply extend the volume on SANtricity
and then expand the ext3 partition ?
Basically I am trying to find the optimal way to partition the
storagetek and allow for the expansion of the partitions in the future.
Tks,
-Bob
The information contained in this e-mail and in any attachments is confidential
and is designated solely for the attention of the intended recipient(s). If you
are not an intended recipient, you must not use, disclose, copy, distribute or
retain this e-mail or any part thereof. If you have received this e-mail in
error, please notify the sender by return e-mail and delete all copies of this
e-mail from your computer system(s).
Please direct any additional queries to: communications@(protected)
Thank You.
--
Taroon-list mailing list
Taroon-list@(protected)
https://www.redhat.com/mailman/listinfo/taroon-list
|
|
