 | | | NIS install | NIS install 2006-02-22 - By Waldher, Travis R
Back
> __ ____ ____ ____ ____ ____ ____ ______
> From: Rold?n [mailto:roldan@(protected)]
> Sent: Tuesday, February 21, 2006 5:19 PM
> To: redhat-install-list@(protected)
> Subject: NIS install
>
>
>
> Hello
> Im setting up a NIS network?and i have configured my server and a client.
> the problem is that when i do the ypinit -s myserver on the client i get
> this error message that sid that ther is not server runig in myserver. but >
when i start up the sistem it say that the bind to the nis domain was
> [ok], what i'm missing here?
> thanks
?
ypinit -s myserver is used to setup another machine as a NIS slave. (A second
NIS server that is a slave of your master.)
If a machine is just a client, all you need to do is configure ypbind.
The reason that you are getting the error that the server is not running on
your client is that ypserve hasn't been set to run at startup. If the machine
is truly a client, you don't want ypserv running.
The next problem you will have, on your master, if when you ran ypinit, you
didn't specify any slave servers that machine will fail to connect to the
master.
__ ____ ____ ____ ____ ____ ____ ____ ____ ____
Redhat-install-list mailing list
Redhat-install-list@(protected)
https://www.redhat.com/mailman/listinfo/redhat-install-list
To Unsubscribe Go To ABOVE URL or send a message to:
redhat-install-list-request@(protected)
Subject: unsubscribe
|
|
|